Well here's the schematic for the VR-241 to RGB and the Video to VR-201 adapters. Hope they come thru alright. i don't have the Radio Shack part number for the power supply handy, But it's about $30 or so and will give about 2 amps @ 13.8 volts. (if you can't find 75 Ohm resistors at Radio Shack, use a couple of 150 Ohm ones in parallel for each.) . . Dec 4PDT VR241 RGB Switch Monitor Cable (Set Monitor --------o Termination off | \ Sync External) | \ | S1a o-----------------------+ Sync Input | / | | / (O)-* | +----o | | Green | | | | (O)-------------o---)----o (BNC | \ Female) | \ | S1b o-------------------o--+ Green Input | / | | | / \ (O)-* (BNC Male) | +--o / | | \ 75 Ohm Red | | / | | \ (O)-----------------)--)-o | (BNC | | \ * Female) | | \ | | S1c o-------------------o---+ Red Input | | / | | | | / \ (O)-* (BNC Male) | | o / | | | \ 75 Ohm Blue | | +--------------+ / | | | \ (O)-----------------)--)-o | | (BNC | | \ | * Female) | | \ | | | S1d o------------)------o--+ Blue Input | | / | | | * = Ground | | / | \ (O)-* (BNC Male) (O)= BNC connector | | o | / | | | | \ 75 Ohm | | +-------+ | / | | | | \ | | | | | | | | | * | | | | | | | | +-------+ +----+ | | | | | | ( ) Phono \ \ \ ( ) Plug /330 /330 /330 (__) \Ohm \Ohm \Ohm || / / / || \ \ \ +----+ | | | | | Toshiba | | | | * Mono 4 5 3 1 Out Toshiba 9 pin RGB Out . . . . For Mono Monitor . . Hookup for Dec VR-201 . . 15 Pin . "D" Connector . . +12 volts ------------------------------- 7,8 . . Gnd------------------------------------- 5,6 . ____ . ___| | . O___| |------------------------------- 12 . |____| . Phono Plug \_______________________________ 4 . . Have Fun!! Rod Lane 72165,655